Jump to content

Stab Temperature Is Growing And Growing Up. It Doesen't Stop.


Recommended Posts

1. Add drink ice cubes

2. check and change temperature sensor

3. Disconnect one heater

Choose the best one.


Man... instead such dramatic entries you should tell much more about the reasons. 

Did you play with physical tankboard settings ? 

Did you change any offsets in the machine ?

Did you screw up the temperature calibration procedure? 

Do you meantime have problems with Dryer - too low drying temperature ? 

POssible that temperature sensor failed, much more plausible that realy on the card worn up and is not disconnecting ( "sticky contacts"). POssible also that instead Stab heater you plugged BL/FIX or DEV heater ( 300W instead 200W) or you swapped connections. 

Link to comment
Share on other sites

  • 1 month later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...