Noritsu With Fuji Ms01

[Guest]

I see some people are sucsesed to install MS01 on Noritsu printers.

Can someone share how it's done? Some mod or just stright way install?

 

Tnx.

[Minilab service]

Only few Noritsu minilabs will be possible to run with MS01. Can do only on Noritsu minilabs, which also where sold as Fuji. Noritsu minilabs can have various replenishment systems ( RA-4, J - ecojet, SM - Kodak replenishment system, F - Fuji cartridge replenishment ) . All Fuji branded Noritsu have only Fuji cartridge replenishment system, so you can have problem with it.   

Also MS-01 software will not support Noritsu scanners. With Fuji branded minilabs used Fuji SP-3000 or SP-500.

[Guest]

I'm asking for machines form QSS-37 series.

Is installation procedure same as in installation guide pdf for MS01 for fuji? Because there is no noritsu machines in setup.ini file.

 

Can someone share installation procedure?

 

Tnx

[Minilab service]

Of course you can't find Noritsu minilabs in list. Have choose Fuji model :

QSS3702F Fuji LP7500  ( minilabs with capacity booster F )
QSS3703F Fuji LP7600  ( minilabs with capacity booster F and capacity booster G )
QSS3704F Fuji LP7700  ( minilabs with capacity booster H )
QSS3705F Fuji LP7900  ( minilabs with capacity booster I )

[Guest]

And what software need to be installed for machine control?

N1_310 or some Noritsu software?

[Minilab service]

I think Fuji software will be used. On other hand can try install Noritsu software and see will MS01 will allow register output device.

[Liza]

Any one have success with running ms01 on noritsu 37?