Lp 7500 Capacity

[surviving]

HELLO I AM WONDERING IF IT IS POSSIBLE TO INCREASE THE CAPACITY OF  PRINTING ON THAT MACHINE  THANK S

[Minilab service]

Try additionally attach capacity booster type G and in minilab specification register as LP7600. LP7500 and LP7600 has the same printer and processor just a little different. 

[surviving]

WebRep

 

currentVote

 

 

noRating

noWeight

 

 

 

 

 

 

 

 

 

 

 

THANK S FOR ANSWER BUT WHAT DO U MEAN BY additionally attach capacity booster type G THANK S AGAIN

[surviving]

THANK S FOR ANSWER BUT WHAT DO U MEAN BY additionally attach capacity booster type G THANK S AGAIN

[Minilab service]

To your minilab ( LP7500 ) already attached capacity booster type  F .  To LP7600 attached capacity booster type  F and capacity booster type  G .

[surviving]

WebRep

 

currentVote

 

 

noRating

noWeight

 

 

 

 

 

 

 

 

 

 

 

SORRY AGAIN PLEASE attached capacity booster type  F IS IT  A HARDWARE OR SOFTWARE??? THE LP 7500 IS NEW FOR ME SO I AM LITTLE BIT CONFUSED THANK S 

[Minilab service]

Capacity booster is hardware ( dongle ) + driver ( Sentinel ) + software.

As I told before to LP 7500 attached only one ( capacity booster type F ) .

To LP 7600 attached two capacity boosters ( capacity booster type F and capacity booster type G ) 

LP7500 printing speed 1180 prints/hour ( 102 x 152 )

LP7600 printing speed 1480 prints/hour ( 102 x 152 )

[surviving]

GREAT MAN U R GENIUS THANK S

WebRep

 

currentVote

 

 

noRating

noWeight

 

 

 

 

 

 

 

 

 

 

 

[Minilab service]

Hello. In this minilab capacity booster hardware consists on two elements - capacity booster PCB + capacity booster. They both inside minilab connected to printer I/F main pcb. Minilab have as many capacity booster PCB as many capacity boosters ( no pcb and boosters, 1 pcb + 1 booster or 2pcb + 2 boosters ) . So it is normal, if you have CD only. Your hardware ( capacity booster PCB + capacity booster or few of them ) will be inside minilab ( printer section ) . 

You can see your capacity boosters in service menu. Go to service mode, Menu, Extension, Maintenance,System Version Check. Look what you see in printer I/F main ( version cpu ) . There you have to see some digits and after them can be some letters. For example if there you see 2.010 FG that means inside your minilab you have F and G capacity booster PCB's + capacity boosters. In this case your minilab would be LP7600. Minilab model should be registered in minilab specification menu. There selected model depends on capacity booster PCB + capacity booster you have. If you choose wrong model your minilab print more slowly.