Qss 3001 And 3301:Colour Setting And Monitor Setting

[murtaza]

Please assist on how to set colour and match the photo with screen. Pls assist step by step so that i can get good quality photos.

Also, can you explain about DSA Settings?

Thanks

[Minilab service]

To have good prints you should have good chemistry and calibration plate. You have run initial setup ( choose correct paper profile ) , make paper profile registration, if you use few master papers ( can be up to 3 ) and magazine registrations for all other paper magazines. If do not like black you have can make manual adjustment. Then make some test prints without any corrections. Would be better to have files and photo printed on some good professional minilab. In paper setup menu change color and density settings for each magazine until you have prints similar with your referent photo. Paper setup should be done for all paper magazines. These corrections can't see on other menu. If it is not enough can add some corrections for each printing channel.

You can enter DSA corrections to print channel, but you can change them for each photo. 

QSS30 monitor can be calibrated with minilab colorimeter. Also can make some adjustments changing monitor settings and in monitor menu. In QSS33 can make monitor profile using special pictures. If do not like results always can change profile making adjustments  in monitor setup menu. Also can make picture profile with any calibrator. Just go to monitor setup and initialize data. Then take calibrator and make profile. Rename it as it is inside Norisukoki folder. Then close down check, F, quit application and replace .icm profile inside Noritsukoki with you new. Then run Noritsu software and your profile will be loaded. 

When we are talking about monitor you should see the same what is on your photo. You can change everything to get it.