Problem With The Strap Plan Printing Dks

[ISLAND PRINT]

Hi! We have a problem with the strap plan Printing DKS. I enclose a photo. Has anyone had this problem? There 'a remedy? Thank you!

[pskaro]

Remove the expo deck, losen the 4 screws on the right plate which is touching the belts and raise it to maximum up position

[pskaro]

Or bend that part which is touching the belts with pliers without removing the expo deck

[fdoruiz]

if you have double magazine, do the same both sides of the exposure dek, check nothing its touching the belts, and based on the picture, you need to replace the belts

[ISLAND PRINT]

thank you for the advice, how can you do to change the belts?

[Studio01]

This is normal, I had the same problem after 9 years on my DKS 1510. The rubber is worn,

so you'll have to change them. I disassembled all and inspected them searching for some

place touching but after cleaning after several days happened again. And the dirt goes to the prints.

 

Studio01

[ISLAND PRINT]

Thanks Studio 1. I want to change the belts but I can not find the code in the spare parts.

[pskaro]

Here i the cat No:

 

N060 376 567 Exposure deck belt set

 

It is sold as set off belts and I think it is very expensive from KIS, try to check at some local shop, but ususally you have to provide the lenght and width off belt and teeth number, maybe to cut some outer belt and remove it ?

 

Regarding this plate touching the belts, I recently had situation like that and problem was coming from right plate off the expo deck wich was position in lowest position (there is about 2mm play up/down for that cover plate), but I did not take a photo off that plate.

[ISLAND PRINT]

Thanks Pskaro, you are always very helpful with your advice, now let's try ...

[relaxia]

expo plane belts are flat if I remember well , no teeth...

[ISLAND PRINT]

yes, but flat with small teeth on the bottom

[panzer]

Got a complete expo deck assembly, in full working order :

 

Exposure panel S/A / S/E Plan exposition 060 376 083D

 

Let me know if you're interested .

Edited September 4, 2014 by panzer

[ISLAND PRINT]

Thank you, we are interested, depends on the price ...

[panzer]

Against the rules dealing in here .

If interested , reach me on pm or at walther65@gmail.com

Edited September 4, 2014 by panzer

[pskaro]

Strange, different cat no from one I posted earlier, are they for DKS2 ?

[panzer]

060 376 083D  is the part number for whole expo deck unit .

[pskaro]

Ohh, sorry, Iwas not reading your post carefully

[ISLAND PRINT]

Hi, before buying spare parts we need to understand the cause of the deterioration of the belts. Strange that both the normal consumption are ruined because ONLY outside the 10. Tensors may be some loose?

[panzer]

You need to replace all the belts , not only the ones who look more damaged , otherwise you will not be able to adjust equally the tension for all belts .

You can check also the rollers , if they are deep warn or have too much play when spin up .

[ISLAND PRINT]

Hi, one question
Putting the new belts will need to change the rollers?

[panzer]

Only if they have deep warn on the belts traces , if not spin up freely , or jogging out of axis .

 

Best way to check that is to normaly assemble the expo deck unit with no belt installed .

[German Tirado Montoya]

Against the rules dealing in here .

If interested , reach me on pm or at walther65@gmail.com

HOW MUCH IS THE EXPOSURE PLANE IF YOU STILL HAVE IN STOCK FOR THE SYSTEM 89 THANKS