Fuji Dp Ii Paper

[adamwooo]

I have a problem with fuji DP II paper, i have profile vol7.19 , i use kodak supra paper, and fuji pearl (on this paper everything is ok). I tried to register new fuji DP II MAT paper , my problem is the black white photo isn't exactly bw. They came a little red. I choose during registration fuji crystal archive DP II paper. How can i get good BW photos ?

Edited April 17, 2015 by adamwooo

[analogman]

Assuming you are using a Noritsu machine, there is a utility to address this problem.  Go into the menu screen, and select "Emulsion number change", then click on the appropriate paper width and magazine number for the surface and paper type you have installed.  The routine will ask for calibration of the colorimiter (on older machines it asks you to insert the calibration plate) When the set up print comes out, follow the directions on the screen. The machine will try adjusting three times, and if the problem is not entirely gone, run the routine again.

 

All this assumes you run your daily or weekly setup using a different paper, or you probably wouldn't be asking.

 

good Luck

Neil W.

[Dave S]

Assuming you have done the paper emulsion setup and the B/W are still a bit red, goto, F, Menu, Extension, Setup, Paper Setup, on the magazine with the Fuji DP II Paper put in a manual correction maybe +0.5C and see if the B/W prints are any better.

Repeat until you are happy with the results.

[adamwooo]

Thanks Dave