Hs1800 Error 1405 00026

[guyverias]

Hello guys i need help with this error msg saying that i need to remove 135 film from carrier. Looking at the help file i need to do 2 things

1. Remove jammed film

2. Clean inside carrier

There is no film inside carrier and i tried method 2 but the problem is still there. I tried the sensor adjustment also still have this error and the adjustment window said terminated abnormally.

Do you know any solution for this error?

Thank you

[Minilab service]

Hello. Are you sure about error number? In manual found 01405-00016 only.

[guyverias]

Hello. Are you sure about error number? In manual found 01405-00016 only.

[guyverias]

Hello. Are you sure about error number? In manual found 01405-00016 only.

Yes im pretty sure it show that error number. The carrier think that rhere is a film jammed inside and it asked to remove the film from carrier. But there is no film. So i read the corrective action would be cleaning the carrier. And i inserted the film carrier again. And the error 1405 came up again.

This carrier eas working fine before. This happens after i inserted the 120 carrier and do calibration. Then i decided want to scan 135 film first, then this happened

[Minilab service]

Yes im pretty sure it show that error number.

 

What do you mean ''that error number'' ? Is it 01405-00016 or 01405-00026 ?

[guyverias]

Hi i saw yesterday the error changes 

its 1405-00006 and also 1405-00016

 

I tried to remove the screw from the top cover, and it worked. when I fastened the screw again it won't work.

I guess the sensor is not perfectly placed. the film carrier info has 135 perforation sensor is DARK. when its DARK it thinks that there is film inside

 

any inputs?

[Minilab service]

When no signal from perforation sensor should be error 1405-00004. You wrote that have 1405-00006 , which doesn't exist. What can we say, if you write wrong numbers.

[Dave S]

The unlisted error numbers 1405-00006 and 1405-00026 are due to the total bit count from multiple error numbers.

In this example it's a combination of:-

1405-00002 135 Ready Sensor

1405-00004 135 Perforation Sensor

 

The resulting Error message is 1405-00006

 

1405-00002 135 Ready Sensor
1405-00008  DX Sensor 1
1405-00016  DX Sensor 3

 

The Error message is 1405-00026.

 

It seems an unnecessarily complicated way of doing it, I don't know why all the error numbers cannot simply be displayed instead. It would make it far easier for everyone to understand what's going on.

Edited October 27, 2016 by Dave S

[NegativeInfo]

Hi Guys, 

I have been getting this error and like OP can not get rid of it, tried cleaning all areas of the 135 carrier, inside and out but same error 01405-00016. 

Did this occur because the 1800 was started up with the 120 carrier attached? Several times I've had issues when the Noritsu was booted 120 attached instead on 135 carrier.

The 120 is fine, I am able to scan, it is only the 135 carrier giving me this issue and can't get around it to get scanning going.

Any help would be really appreciated, thank you very much!

Robert

[TECNOR]

Try to do adjustment sensors 135