QSS 3300

[Sait Terekli]

on noritsu 3300, i ajust daily setup from 152 paper. Than adjust emulsion 203 setup, up to now all OK.

Than i want to print from 152 paper, colors are not good, they become yellowish. Than i adjust daily setup again, 

color is ok. i take out and in again same magazine 152. i adjust daily setup again, colors become yellowish again, WHY?

And there is no any alarm, print engine input check and output check are OK. B aom is defective i think, ???

Sait Terekli

saitterekli@hotmail.com

[Edwin]

up same of my printer

[Minilab service]

First try to replace B AOM driver. Might be it is faulty. When you open door power supply is disconnected from AOM drivers. When you close - power supply connected back.