Dryer lamp dks kiss 1530

[Ljiljana LM]

 

Hello everyone, I have a problem with the dryer lamp after 5 photos are turned off only after I restart the machine and the same problem with the 5 photos is gone and it stops. The lamp is new and has been blotted with the same old thing ... it goes off

[pskaro]

That is the densitometar lamp, it should be ON only during during measuring the paper test

[Ljiljana LM]

6 hours ago, pskaro said:

That is the densitometar lamp, it should be ON only during during measuring the paper test

 

The problem is getting wet paper out of the way I got directions then guess where the error would be

Pskaro where and can I get directions for dks 1530?

Edited April 30, 2017 by Ljiljana LM

[pskaro]

If the prints are coming wet from the dryer, then there is a problem with in a dryer.

There are several items to check, most common is blown thermal fuse (there are two inside, replace both, less then 1€ each), bad motor capacitor and that is the most common reason for blowing of the thermal fuses as it starts later and heaters are already ON (it should be 1.5uF, but over time it's capacitance is going down, replace it, less then 3€). Then it could be the heaters itself, but they are wired separately, so if one is bad then the other should work, thermal probe (NTC resistor) or the bad contacts of that probe on the board or in the connector, and on the end, very rearly, the heater or blower SSR relays.

Two days ago I repaired one same dryer (customer brought complete section blower+heater assembly to my work place), I found one blown thermal fuse (I replaced both, as the other one looked bad), and blower capacitor measured at 1uF and it should be 1.5uF, I replaced it with the same value, checked the heaters and thermal probe, and both were OK, and that was it

 

Edited May 1, 2017 by pskaro

[pskaro]

By the way, I charged the customer only 50€ for that repair, probably too little, but it was easy to diagnose and fix, and I did not have to go on site, so...

Edited May 1, 2017 by pskaro

[Ljiljana LM]

 

Thanks for the guidelines, but let's hear it if we go and we agree on what and how because the machine in Zagreb....

[pskaro]

Zar vam Milan inače ne servisira stroj ?

Edited May 1, 2017 by pskaro