Connection lost between LP7500 and Server

[Ahtong]

Please help me

can't connect to the printer from my computer.

already changed the network card of the LP7500.

i see the red alert from the BoosterF circuit beside the network card.

What should I do?please help me.

Thank you.

.

[Minilab service]

What do you see on display module? Check IP and mask from display module. 

Are LAN settings well on computer ? Run ping from computer ( Start, run ''ping xxxx.xxxx.xxxx.xxxx -t'' ) . Instead x - your minilab IP address. You shouldn't have errors.

LP7500 has not separate LAN card, so what you changed?  LAN is integrated on İF/PCB. There can change IP address using LAN or from display module.

[Ahtong]

I01920-1024

CAPACITY BOOSTER

that is what I see on display module.

Can I contact you on Facebook,sir

so I can tell you the problems facing on my printer

thanks sir

[Minilab service]

Hello. I01920 means capacity booster key was not detected. You didn't tell you changed İF/PCB or not. If yes - probably you did not all steps, which have to be done after replacement and that is the reason why you see this error.

Booster F has 5 LEDs. LED1 - OFF, LED2 - ON, LED3 - OFF, LED4 - OFF and LED5 - ON . 

On display module you can browse to network settings menu on your minilab ( IP and mask ) . There default address 192.168.1.11 and mask 255.255.255.224 . In this case from computer should run text   ping 192.168.1.11 -t    to see connectivity between computer and minilab.

If you have not ping errors then run Fuji printer software. Then try to add your printer ( enter settings, which where there before ) . Set miunilab specification, read backup and all should work.

[Ahtong]

Hi sir

led 2 and led 5 on BoosterF are ON

but led 2 color is red and led 5 is green

i didn't changed IF/PCB

Edited May 31, 2017 by Ahtong

[Minilab service]

If led 2 and led 5 on Booster F are ON than it should work. Might be you have some software problems. If you suspect that booster faulty just remove it. IF/PCB should work without it ( Noritsu QSS3701, QSS3501 PLUS, Fuji 7100 have not any boosters ) .

Did you look what IP on your minilab ( can find browsing display module menu ) . Did you run ping from computer to minilab? Do you have errors, or all OK there?

Use correct LAN cable to connect computer and minilab. If connected directly ( without hub ) should be used crossed LAN cable. If connected through hub - LAN cable should be straight.

On computer LAN settings ( IP, mask ) should be static. Do not use automatic mode there.

First you have know that have communication between computer and minilab. Only after that can work with software.

[Ahtong]

thank you so much