QSS 3101 Magazine Emulsion Change

[elmo4599]

Lab has three 3101 that we still use for production work.  We have one 3101 that is set up differently than the other two and I cannot figure out where in the software the different setting or selection exists.  Two 3101 run the F series software (same version) and the other runs the G series software.  One machine running the F series software when the magazine runs out of paper it prompts a magazine change just like all the others do as well.  BUT one 3101 allows us to run a paper emulsion balance before it continues on to the print job.  The other two 3101 do not "ask" for this and I cannot for the life of me find where in the software this selection exist to change the other two machines to prompt the emulsion setup after magazine change.  Getting too tedious to select no on restart and then have machine error out and I have to reload job again from where it left off.  Hope that makes sense as I really could use an answer.  

[Magenta]

long time on a 3101 but expect a setting in operator selections, you will have settings like feed lead paper when loading, have a look

[elmo4599]

I forgot all about this post but operator selections are not it.  We can restore from the "good one" to another 3101 and it does not ASK for the emulsion change so it has to be a setting maybe in service mode or somewhere embedded that is not seen.  Any other ideas.  (Promise not to wait to long for the next post...lol)