Statistics of orders sent to the frontier 330, 550, 570 from C4 / C5 (Fdi)

[servitel]

Good evening friends, I wanted to ask you if there is any way to control the prints on the frontier with the C4 / C5 Fdi software to determine which stations are being sent. What happens is that I need more control over the photographic material and I have only been able to access the production totals but it does not give me a detail of the stations that have sent orders. Thank you.

[Minilab service]

To control orders have to use frontier manager. For FDIA ( A1, C4/C5 and optional modules ) you need E3 software. Have two versions - full and light.

[servitel]

Thanks for the reply. Look for that software and it turns out that if I have it. But when I install it, it gives me database errors and I do not have a reference manual for its installation. I do not know if it should be installed in DIC or Frontend or in the FMPC. I do not know which version (Full or Lite) is installed. Is there a reference manual?

[Minilab service]

Frontier Manager LITE - E3-L Ver.2.0-0E-140

Frontier Manager FULL - E3-F Ver.2.0-0E-050

If have not manual for E3 then can use S8 manual.