Recovery FC7011

[TECNOR]

Hi all, 

I have the recovery FC7011 but never restore an image with PQI extension.
Could somebody teach me please?

what  program do I use to restore this, because the current hard drive is damaged.

what should be maximum capacity the new hard disk, currently  I can only get hard disk with a minimum capacity of 500Gb.

I always created and restored image files with acronis true image .

regards..

[Minilab service]

This CD is bootable. You do not need software to restore HD.  Just go to BIOS  settings and choose boot from CD. Then put CD and boot from it. After recovery on HD you will have only pre-installed Windows 2000.

After that have re-install all software - main A1 and optional. Then have install connection software. What to install depends on server software ( FDIA, FE or MS ) .

During A1 software instillation you need backup floppies ( for scanner and printer ) . Check are they alive - try copy floppy files to  HD or USB. If have copy error then floppy is broken. It is possible to use folders ''prin'' and ''scan'' from Fuiifilm\Frontier\Param. Settings are there.

If have Acronis file can restore again. It would the easiest. To recover is enough 40 GB HD. Of course it can be bigger. Pay attention - on 7011 used IDE hard disk ( not SATA ) .

Have all software for all possible systems. Also have all optional modules.

Edited January 20, 2018 by Minilab service

[TECNOR]

Thanks for your Reply Minilab service aslo I want know if recovery  FC 7011 is the same.FC7010.

Regards..

[Minilab service]

Yes, these computers are the same. Difference - only RAM.