Color trouble on QSS 3111

[Forestyl]

Good day Sirs.

Our 3111 suddenly devellop a color problem on prints ater we blowed dust from AOM drivers section. on doimg so, we removed the AOM drivers  and connect hem back properly. Now the prints are only green. We intended to perform an initial set up but we noticed our way is wrong. Please we need help. See attached printed photos.

Thank you.

[Minilab service]

Check 5 pin connectors on AOM drivers. Might be you messed them, when connected back. Also check BNC connectors ( inputs and outputs ) .

Yes, you shouldn't make initial setup. Hope you did backup before it? If you did just load it and all settings should return.

[Forestyl]

39 minutes ago, Minilab service said:

Check 5 pin connectors on AOM drivers. Might be you messed them, when connected back. Also check BNC connectors ( inputs and outputs ) .

Yes, you shouldn't make initial setup. Hope you did backup before it? If you did just load it and all settings should return.

I was disconnecting, cleaning and connecting the AOM drivers one after another. I just check as you suggest and no mistake was done. But before my collaborator disconnected the laser driver pcb, the first one at the right side of the box (J390796-02). I thought of the jumper setting on the connector P1533 but no change. In output check, only red laser is synchronising. The machine is making no alarm.

Edited January 27, 2018 by Forestyl

[Forestyl]

2 hours ago, Minilab service said:

Check 5 pin connectors on AOM drivers. Might be you messed them, when connected back. Also check BNC connectors ( inputs and outputs ) .

Yes, you shouldn't make initial setup. Hope you did backup before it? If you did just load it and all settings should return.

Now everything is OK. Was wrong BNC connection on green AOM driver. Could notice it at the fourth check after you suggest.

Once more thank you for sympathising.