Jump to content
Sergio Fassio

Noritsu 3202 6017-0001

Recommended Posts


I have the problem that the paper transport to the cutter, cuts and it will not feed to the exposure unit, then the error appears

I already check the arcnect connection with the self checks and everythings success

Also check the ligth lock door and works normally

Do you have another idea?

Share this post

Link to post
Share on other sites

Exposure start sensor ( SE14 ) is in the middle on exposure advance unit. Clean this sensor.  Then try to calibrate sensors from paper sensor adjustment menu. Can calibrate manually, or automatically. 
To check sensor need open top cover and on cover sensor put magnet. Then can close - open sensor with paper and look changes on input check. Also can use multimeter. 

Share this post

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Create New...