falis 0 Posted December 18, 2020 Report Share Posted December 18, 2020 I'll show You how i replaced damaged rubber whells in Noritsu 120 Carrier. What You need is: screwdriver, drill driver, sandpaper (I used 180), flat tap washers (I used silicone 3/8"), super glue. 1. Remove shafts with damaged rollers. 2. Put tap washers on shaft. Using drill driver, and sand paper reduce size of tap washers to size You need (10mm). 3. Using super glue stick reduced tap washers in right place on a shaft. 4. Put all together, and You'r done. Everything works just fine, and cost was about 3$. Enjoy. https://youtu.be/aF6YmQNNsyY Quote Link to post Share on other sites
davidlam 25 Posted December 18, 2020 Report Share Posted December 18, 2020 was film scanning result good afterwards... ? Quote Link to post Share on other sites
falis 0 Posted December 19, 2020 Author Report Share Posted December 19, 2020 Everything works fine. https://youtu.be/YfyzOKKYrOw Quote Link to post Share on other sites
ProImagePhoto 0 Posted January 13 Report Share Posted January 13 This is great info! Thanks for sharing. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.