Jump to content

LP2000 fail to install


Forestyl
 Share

Recommended Posts

Good evening.

I am i installing Fuji LP 2000 using Fe softwares (S9). The installation starts up normally, but at the end, it will refuse to transfer control software to the printer.

Error 233 as shown on the attached. picture.

After I change FMA20, FMC20, CTL20, Firewire card on the computer, even the computer itself, no change ; I check the firewire cable using a multimeter and the cable is fine.

I need assistance please.

20210717_085737~2.jpg

Link to comment
Share on other sites

  • 2 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
×
  • Create New...