Jump to content

Synchronizous sensor, error on qss 30


Tengi2
 Share

Recommended Posts

Hi every one.

I have faced the above error two times at an interval of one week, everytime I resolved by switching the machine off for 5 hours and than switched on, the error is gone, when it happen I swaped the AOM drivers, but the error code remains the same. Any help in solving this error permanently.

ThanksIMG_20210822_164245.thumb.jpg.6cd0287137eef1d1627e7cada4c0bba1.jpg

Link to comment
Share on other sites

The suffix 0003 reports about the problem with a blue channel of the lab.
First you should pay attention to the condition of AOM driver of the blue channel.
You can swap it with any next AOM driver because they are interchangeable.

If the swapping will not solve the problem you should check a blue laser module.
I will inform you how to check the condition of it after results of swapping.
All these procedures I have described on my website before.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

×
×
  • Create New...