Thi Posted September 8, 2021 Report Share Posted September 8, 2021 So I replaced the Ps with new water and then all of a sudden P1 doesnt heat up normally since then It was working the day before and suddenly when I replace water for Ps heats up as usual but P1 doesnt anymore I havent touch P1 and was just replacing water for the Ps No.05532-00000 The processing solution safety thermostat has activated keeps appearing and stopping the heating up process I tried to clear the error until the P1 heated up to correct temp but I cant be doing this everyday because its too time consuming What and where should I start looking at? to fix this problem appreciate the help Quote Link to comment Share on other sites More sharing options...
yustas Posted September 8, 2021 Report Share Posted September 8, 2021 There is a heater inside a tank. The heater controlled by a solid-state relay SSR. Check it. Contact me if you need a wiring diagrams. Quote Link to comment Share on other sites More sharing options...
Dave S Posted September 9, 2021 Report Share Posted September 9, 2021 The cause of this error is usually a blocked chemical filter or circulation pump. Take the chemical filter out and check you have good circulation in each sub tank. Quote Link to comment Share on other sites More sharing options...
Thi Posted September 21, 2021 Author Report Share Posted September 21, 2021 Thank you for the responses I just cleaned the chemical filter for now and P1 is heating normally again Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.