Jump to content

Horizontal banding on DX100 prints.

Christina Rose

Recommended Posts

Dear All,

I am facing Horizontal banding with Dx100 prints. sample image is attached. if anyone can shed on light on this issue will be highly appreciated.

Nozzles are fine. ( diagnostic cleaning completed Ok message)

Cleaned PF motor wheel, Encoder, feed motor Sensor  etc...

Re installed print head as per installation manual. even changed with another new head. done all the adjustments as per check list. but issue is remains.

Thanks and Regards

Christina Rose.





Link to comment
Share on other sites

  • 2 weeks later...

  • 2 months later...
  • 4 months later...

@Christina Rose Can you print a manual nozzle check pattern and upload a high quality scan? I've seen this issue on 2 of our DX100's now and both times it was mis-firing nozzles, this can be seen on a close inspection of the nozzle check pattern as either one persistently out of place, or the lines between the colours are un-even/wobbly, both times this has been a printhead fault for us

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Create New...