chitrakoot Posted April 26 Report Share Posted April 26 hello i have fuji frontier 570..last day 1 message appear that was P1 safety thermostat(D700) activated.The heaters (H 700 to H703)turned off. i shut down the machine and after 30 min. or so i started machine but it stack on (_)this line and not start up..pls anyone suggest what to do...i change Ram and ctl 23 board but no response..pls suggest thanks Quote Link to comment Share on other sites More sharing options...
Fujifrontier Posted April 27 Report Share Posted April 27 Hi Chitrakoot, can you tell one think that in Display there is two LEDs “Power 1 & Power 2”.What’s a color of these LEDs? Quote Link to comment Share on other sites More sharing options...
chitrakoot Posted April 28 Author Report Share Posted April 28 both are green Quote Link to comment Share on other sites More sharing options...
chitrakoot Posted April 28 Author Report Share Posted April 28 Quote Link to comment Share on other sites More sharing options...
chitrakoot Posted April 28 Author Report Share Posted April 28 Quote Link to comment Share on other sites More sharing options...
Fujifrontier Posted April 28 Report Share Posted April 28 there is no stack on display? Take out imaging box,make it clean and restart again. Quote Link to comment Share on other sites More sharing options...
chitrakoot Posted April 28 Author Report Share Posted April 28 Quote Link to comment Share on other sites More sharing options...
chitrakoot Posted April 28 Author Report Share Posted April 28 where i found that imaging box..pls suggest Quote Link to comment Share on other sites More sharing options...
chitrakoot Posted April 28 Author Report Share Posted April 28 is it GMC Box? Quote Link to comment Share on other sites More sharing options...
Fujifrontier Posted April 30 Report Share Posted April 30 Yes whole box of Gmc Quote Link to comment Share on other sites More sharing options...
Fujifrontier Posted April 30 Report Share Posted April 30 (edited) What is the actual problem?Some time displaying with stack and some time totally blank on display.So, do one think that restart a printer several time and you will find which is the main problem. Edited April 30 by Fujifrontier Quote Link to comment Share on other sites More sharing options...
chitrakoot Posted April 30 Author Report Share Posted April 30 one dot appear while start the minilab...this is the main issue Quote Link to comment Share on other sites More sharing options...
Fujifrontier Posted April 30 Report Share Posted April 30 (edited) If so then replace “RAM” of GMC23 Board.And also before remove P1’s Safety thermostat from heater and hang it don’t remove connector of it. Edited April 30 by Fujifrontier Quote Link to comment Share on other sites More sharing options...
chitrakoot Posted April 30 Author Report Share Posted April 30 ALREADY CHANGE RAM...ANY OTHER WORK TO DO..PLS SUGGEST Quote Link to comment Share on other sites More sharing options...
Fujifrontier Posted April 30 Report Share Posted April 30 Please change one more time with another RAM Quote Link to comment Share on other sites More sharing options...
chitrakoot Posted May 5 Author Report Share Posted May 5 problem solved by change gmc 23 board..but after 1 day of worked new error appear i.e E2501(Anti dust Shutter Abnormal)..pls suggest Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.