mike11918 Posted May 2 Report Share Posted May 2 So I’m getting these odd yellow lines periodically and am unsure what it could. Any suggestions would be great. Running a Noritsu 3313. Quote Link to comment Share on other sites More sharing options...
Minilab service Posted May 3 Report Share Posted May 3 It is noise on B channel. Might be bad B laser head or unstable synchronisation. Run laser test software and find the minimal value, when you have B synchronization. Try to swap B AOM driver with other channel ( R, or G ) . If will be the same - probably noise is from B laser head. Once I had yellow noise, because laser control pcb was faulty. This pcb can be tested on QSS32 and QSS33. There might be different board model, but they are exchangable. If will need I have QSS33 laser control pcb and B laser head. Quote Link to comment Share on other sites More sharing options...
PHOTOLABPART.COM Posted May 4 Report Share Posted May 4 Respected Sir Blue Aom problem Chek ploygon mirror frequency for B,G,& R laser & update me My whatsapp number is +917383343040 Thank you Quote Link to comment Share on other sites More sharing options...
yustas Posted May 5 Report Share Posted May 5 In most cases a culprit behind it is a faulty blue laser module. Please contact us if you need it from the manufacturer. Quote Link to comment Share on other sites More sharing options...
mike11918 Posted May 5 Author Report Share Posted May 5 Thank you. For now, I am continuing to print as is. Problem is very sporadic. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.