kscurry1 Posted January 20 Report Share Posted January 20 I need to shut my Noritsu 3801G down for awhile and after I drain all the chemistry I need to fill it with water and circulate it through the tanks, how do I do that? Thank you. Quote Link to comment Share on other sites More sharing options...
Dave S Posted January 20 Report Share Posted January 20 You power off the machine at the breaker switch. Drain the chemistry from the taps on the bottom left of the processor section. Then take out the chemical filters and fill the tanks with water. Switch on the machine to circulate the water. Quote Link to comment Share on other sites More sharing options...
kscurry1 Posted January 20 Author Report Share Posted January 20 Thanks, so just turning on the machine causes the water to circulate? My supervisor at work was saying I had to go into the EZ controller software to tell the machine to do it. Quote Link to comment Share on other sites More sharing options...
Dave S Posted January 20 Report Share Posted January 20 (edited) 7 minutes ago, kscurry1 said: Thanks, so just turning on the machine causes the water to circulate? My supervisor at work was saying I had to go into the EZ controller software to tell the machine to do it. Yes, as long as the processing tanks are fully filled it will circulate the same as it does with the chemistry. Edited January 20 by Dave S Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.