Tubylec1982 Posted February 27 Report Share Posted February 27 Hello. What can cause visible grain/noise in digital photos. This is visible after printing, it is not visible on the computer. G laser was repaired by the service. In addition, despite the repair, the G laser error message will sometimes pop up. Especially with a lot of photos. And sometimes after finishing printing as the laser is not active. Quote Link to comment Share on other sites More sharing options...
Minilab service Posted February 27 Report Share Posted February 27 (edited) Hello. Here is Green laser head instability. Need to repair, or change laser head. If want I can repair it. What is laser head type A1, B1, or Ff ? Edited February 27 by Minilab service Quote Link to comment Share on other sites More sharing options...
Tubylec1982 Posted February 27 Author Report Share Posted February 27 The symptom of Green laser head instability is this noise right? Quote Link to comment Share on other sites More sharing options...
Tubylec1982 Posted February 27 Author Report Share Posted February 27 It was being repaired because it had completely burned out. That's what they said on the service . Previously, the red stripe in the picture was there. It's under warranty now. So I have to send it back . Quote Link to comment Share on other sites More sharing options...
Tubylec1982 Posted February 27 Author Report Share Posted February 27 (edited) Laser is2.019 X1 Ff1 N Edited February 27 by Tubylec1982 Quote Link to comment Share on other sites More sharing options...
Minilab service Posted February 27 Report Share Posted February 27 If I see correctly noise has Magenta color. If yes - it is from green laser head. Laser unit is Ff type. Green laser head is made by Showa optronics. Need repair this laser head. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.