sinanakyol Posted April 8 Report Share Posted April 8 Hello I put a new cartridge in the frontier 330 and it was mixing. After finishing. It says. Der is a rest of regenerate still there you need technical help. Can i reset the number of prints somehow ? Quote Link to comment Share on other sites More sharing options...
Minilab service Posted April 10 Report Share Posted April 10 That means when printed amount of pictures your replenishment tank should be empty, but minilab still see liquid. Can be that replenishment works wrong, or sensor is dirty and doesn't work. Drain all replenishment tanks. One by one remove replenishment level ( upper and lower ) sensors and wash/clean them. Carefull - do not mess sensor connectors, or sensor positions. Go to input check. Make sure, that all replenishment tanks are empty. Put cartridge and make initial replenishment procedure. Calibrate replenishment pumps. If you do all that this problem will not return. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.