tshicode Posted May 25 Report Share Posted May 25 hello, I have a noritsu 3311 it displays an error ARCNET communication error. Processor. [6901-0008] Quote Link to comment Share on other sites More sharing options...
yustas Posted May 25 Report Share Posted May 25 Pease read here. I wrote it long time ago. Hope it will help you. tshicode 1 Quote Link to comment Share on other sites More sharing options...
Minilab service Posted May 25 Report Share Posted May 25 You have not ARCNET communication between printer control pcb and processor control pcb. Probably problem is on processor control pcb. Check do you have 5V power supply on processor control pcb. Try on processor control pcb clean ARCNET connectors and trim ends of ARCNET cables ( 90 degrees ) . tshicode 1 Quote Link to comment Share on other sites More sharing options...
PHOTOLABPART.COM Posted May 25 Report Share Posted May 25 YES THIS IS PROBLEM BEETWEEN ARCNET - PROCESSOR CONTROL PCB -0008 FOR PROCESSOR CONTROL PLEASE CLEAN CABLE AND TRY IT THANKS tshicode 1 Quote Link to comment Share on other sites More sharing options...
Jhun Posted May 31 Report Share Posted May 31 Hi Try to disconnect the Fiber Optic cable and reconnect it see what's happen Thanks Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.