Thi Posted July 25 Report Share Posted July 25 As the title says Every time at the start of each new print job it has this excess white strip 2-3mm which i have to trim off manually every time which is very annoying only from the first print page then every else prints without it I use the noritsu program Any ideas why? Thanks Quote Link to comment Share on other sites More sharing options...
Dave S Posted July 25 Report Share Posted July 25 I'm assuming this is a Noritsu produced chemistry Minilab? as you didn't mention the model number. If so, you need to carry out the Paper Advance Length Correction. Quote Link to comment Share on other sites More sharing options...
Thi Posted July 27 Author Report Share Posted July 27 fuji froniter Lp7700 I tried the Paper advance length correction for size 152 (6inch) the 1st paper is 152mm & 2nd reads 200mm after inputting values in, I then do test confirmation which reads 150mm & 200mm Do I change the input values afterwards for the 1st test since it change 152 to 150? Quote Link to comment Share on other sites More sharing options...
Thi Posted July 27 Author Report Share Posted July 27 ok nevermind i think it worked Do I need to do this for the others sizes? Quote Link to comment Share on other sites More sharing options...
Minilab service Posted July 27 Report Share Posted July 27 If you on Fuji LP-7700 use Noritsu software then you have Noritsu QSS3704F . Better was post on Noritsu forum and ask about this model. On paper advance length correction menu need test paper advance. Then need measure and enter measurement results. Need do it from all paper magazine positions ( A, A2, B, and C - when minilab has 4 paper magazine positions ) . Test need to do only one paper from each position. For test on different positions can be used the same, or different paper magazine. Quote Link to comment Share on other sites More sharing options...
Dave S Posted July 27 Report Share Posted July 27 7 hours ago, Thi said: fuji froniter Lp7700 I tried the Paper advance length correction for size 152 (6inch) the 1st paper is 152mm & 2nd reads 200mm after inputting values in, I then do test confirmation which reads 150mm & 200mm Do I change the input values afterwards for the 1st test since it change 152 to 150? 6 hours ago, Thi said: ok nevermind i think it worked Do I need to do this for the others sizes? The correction is a global one per magazine position (B/ C etc) so you only need to do this correction on one paper width. You just input the measured value from the test prints, the machine will work out the correction required. No need to thank me, you're welcome to the free help! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.