Jump to content

1026code Close the Printer Top Cover Qss3201 SD


Tubylec1982

Recommended Posts

Hello, I have a problem. While i was  working, the message"close the printer top cover" appeared even thout it was close.The magnetic sensor looks like it works. It was checked with a multimeter. After reseting , it won't turn on.  The rod light on the top of the sorter is flashing.

Link to comment
Share on other sites

Open top cover and on sensor put magnet. If have not - remove from cover.
Check do you have 24V on sensor output ( between ground and LASER I/O PCB connector J/P1533 - pin 4 )
If do not have 24V there then check 24V circuit 
Between ground and LASER I/O PCB connector J/P1533 - pin 1 ( 24V before sensor )
Between ground and LASER I/O PCB fuse F3 ( 24V on both sides ) 
Between ground and LASER I/O PCB connector J/P1541 - pin 2 ( 24V from power supply ) 

 

Edited by Minilab service
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...
DL650
DX100