Jump to content

06016-00004 Paper Cutter operation error help LP7700


Thi

Recommended Posts

 

This is first time that this has happened

After not using Lp7700 for some time

I turned on to have this error 

I found on the manual that it says

06016-00004

Even when a specified time has passed after the cut operation was completed and the cut end sensor turned
LIGHT, the cut home sensor does not turn DARK.

It doesn't really tell about how to fix it

Do I need to replace sensor SE8 Home Sensor? SE9 End Sensor? Dm1 Cut Motor?

I have check the output section and cut home sensor is dark

so when it moving paper the cut home sensor should be still dark or light?

Link to comment
Share on other sites

Open printer door and on door sensors put magnet. Software should see, that doors are closed. Then go into output check menu and try to run cutter motor. Look cutter moves, or not. Broken cutter motor is typical problem on minilabs made by Noritsu. Fuji LP7700 is one of them ( Noritsu QSS3704 F ) .
If motor moves then test sensors. Try open and close them and on minilab software look status changes.

Link to comment
Share on other sites

RESPECTED SIR 

PLEASE CHECK J/P242 connect to printer I/O PCB-2 and paper end sensor B 

J/P 258 TO PAPER CUT MOTOR 

J/P 261 CONNECT TO CUT HOME SENSOR AND CUT END SENSOR 

J/P 262 CONNECT TO PRINTER CONTROL PCB 

J/P 263 CONNECT TO POWER SUPPLY FROM PRINTER I/O 1 PCB

 

PLEASE CLEAN ALL CONNECTORS AND REFIX IT I HOPE ITS OK 

 

THANKS 

 

 

 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...
DL650
DX100