Jump to content

Fujifilm frontier sp1500 + frontier 350 - laser problem


tpovod

Recommended Posts

hello everyone, I'm asking for your help, sorry, I don't know what to do...
So I had a problem with the laser first, then I tried another laser and tried to set it up but it didn't work, then I used the original laser but it also gives me problems. I then replaced the AOM. But now I have problems as shown in the attached photos.

I appreciate your help

frontier184.jpg

frontier183.jpg

frontier1182.jpg

Edited by tpovod
Link to comment
Share on other sites

What you see when connected other laser unit? Is yellow good there?

Blue light on paper is too weak. You have correct Yellow only on light area. Blue synchronization also doesn't work.

Your AOM works. I see Yellow color density steps (  except dark area ) . Might be AOM driver power is not enough. Try temporary swap G an B AOM drivers. Look what will be after that.

Also can be that AOM driver power is enough, but AOM crystal doesn't work properly. AOM crystal is inside laser unit. Need experience to change and adjust it.

The same can be when B laser is weak. Need to see menu with B laser settings and screenshot with exposal check  menu.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...
DL650
DX100