Noritsu Multiple error 06015-00001 06241-00000 06210-00005

[amrit]

I am having error first 06015 saying Paper didn't rewind . I checked but magazine are good and changed another magazine also still got same error. So i kept B empty then i get 06210 Paper supply unit Jam. I clean all paper end senor  advance roller but still this error is not going out. please help

[Dave S]

Which machine model?

[amrit]

Noritsu QSS-3703HD F

[Dave S]

Try doing the paper sensor Adjustment in Maintenance, Printer Mechanical Adjustment, menu.

[amrit]

Printer Sensor Adjustment Done with only both Paper end sensor B and paper Loading Sensor Result - 0. I also placed 10 on both but still same issue of paper supply Jam . I cleaned sensor SE7 and Se4 but still having same issue.

[amrit]

Is there a way to disable SE4 Sensor ?

[Dave S]

14 hours ago, amrit said:

Is there a way to disable SE4 Sensor ?

Only electronically, by connecting the output of the sensor to either + or GND 

[Dave S]

14 hours ago, amrit said:

Printer Sensor Adjustment Done with only both Paper end sensor B and paper Loading Sensor Result - 0. I also placed 10 on both but still same issue of paper supply Jam . I cleaned sensor SE7 and Se4 but still having same issue.

In most cases the reason the value goes to 0 is due to bad connections going to the sensor PCB's. Unplug and re-plug both the sensor and the LED side, then try doing the sensor adjustment again.

[alexvigor]

Sometimes they make plastic ties that hold wiring  too tight. With time excessive pressure may damage the wires. I would replace the ties and look at the problematic sensors output in the output check menu while replacing. If you see sensors go alive you should fix the wiring (although ties replacement can help on its own)