transportation problem

[tsasse]

good evening engineers I have a problem with my minilab fuji frontier 590 when I run the prints the machine does not run no reaction, how can I get the transpo to run

[Minilab service]

Do you mean processor doesn't start? Do you see any error when you start it?

Try to run M700 motor from processor I/O check menu. Look if you have 5V and 24V power suppliers ( motor driver connector CN601 ) .

If have power suppliers, but motor doesn't run then faulty motor, or motor driver.
On connector CN602 should be motor 5V control signals : contact 2 - ON/OFF , contact 3 - direction, contact 5 - CTL ( 5V pulses, frequency depends on speed ) . I think they will be good, but can check just in case.

Motor M700 - Kokusan TL1149, Fujifilm part number 118C1060919 , 118C1060919A . Motor driver - Kokusan TP1149, Fujifilm part number 141D1060898B , 141D1060898C .

[tsasse]

Thank you very much minilab service, but when I run start to turn the M700 motor no reaction 

[tsasse]

7 minutes ago, tsasse said:

Thank you very much minilab service, but when I run start to turn the M700 motor no reaction 

 

On 12/31/2025 at 8:48 PM, Minilab service said:

Do you mean processor doesn't start? Do you see any error when you start it?

Try to run M700 motor from processor I/O check menu. Look if you have 5V and 24V power suppliers ( motor driver connector CN601 ) .

If have power suppliers, but motor doesn't run then faulty motor, or motor driver.
On connector CN602 should be motor 5V control signals : contact 2 - ON/OFF , contact 3 - direction, contact 5 - CTL ( 5V pulses, frequency depends on speed ) . I think they will be good, but can check just in case.

Motor M700 - Kokusan TL1149, Fujifilm part number 118C1060919 , 118C1060919A . Motor driver - Kokusan TP1149, Fujifilm part number 141D1060898B , 141D1060898C .

Thank you very much minilab service, but when I run start to turn the M700 motor no reaction 

 

[tsasse]

On 12/31/2025 at 8:48 PM, Minilab service said:

Do you mean processor doesn't start? Do you see any error when you start it?

Try to run M700 motor from processor I/O check menu. Look if you have 5V and 24V power suppliers ( motor driver connector CN601 ) .

If have power suppliers, but motor doesn't run then faulty motor, or motor driver.
On connector CN602 should be motor 5V control signals : contact 2 - ON/OFF , contact 3 - direction, contact 5 - CTL ( 5V pulses, frequency depends on speed ) . I think they will be good, but can check just in case.

Motor M700 - Kokusan TL1149, Fujifilm part number 118C1060919 , 118C1060919A . Motor driver - Kokusan TP1149, Fujifilm part number 141D1060898B , 141D1060898C .

Minilab service engineer where the motor with reference 118C1060919A in the printer 

 

[Minilab service]

M700 is motor, which rotates processor. If no reaction when you start M700 motor from processor input/output menu then faulty motor, motor driver, or control circuit. I wrote everthing what should be there. Check what you have on motor driver connectors CN601 and CN602 .