Fuji frontier 2877

[Алiна Тагiльцева]

Please help, my Fuji Frontier 570 won't start with error 2877.

[yustas]

You need to pay attention to the GPA23 circuit board.
Perhaps the board is faulty, or you have poor contacts with all incoming cables.

Try to reconnect them.

[Алiна Тагiльцева]

I can't find the GPA23 board. Where is it?

[Алiна Тагiльцева]

I don't have a scanner

 

[Алiна Тагiльцева]

23 hours ago, yustas said:

You need to pay attention to the GPA23 circuit board.
Perhaps the board is faulty, or you have poor contacts with all incoming cables.

Try to reconnect them.

Hi. I can't find the GPA23 board. Where is it? I don't have a scanner

[yustas]

Are you sure of the error code?

[Алiна Тагiльцева]

37 minutes ago, yustas said:

Are you sure of the error code?

Yes. Periodically, the machine turns on and prints a random number of photos, then returns error 2529 SOS. After rebooting, 95% of the time, it returns error 2877.

[Minilab service]

GPA23 is inside image box. No problems there. This board works well.

E-2877 means abnormal LDD23 board L+5V power supply is detected. Check power suppliers on LDD23 boad input and check fuses on LDD23 board. If all well, but still have E-2877 then need change LDD23 board.

If on printer is older R laser head then can use LDD23 with any revision. If on printer is new type R laser head then board should have the latest revisions ( 857C1059597G , or 857C1059597GH ) .

Edited February 20 by Minilab service

[Алiна Тагiльцева]

Sorry I haven't written in a while (:. This problem was solved by repairing the LDD23 (an open resistor in the 5V dazer power supply circuit). Thanks for the advice.