noritsu 3111

[arturo huevo duro]

Does anyone have the manuals for the Noritsu 3111?

 

Does anyone know the correct order for the LVDS and Arnet PCI cards?

 

 

 

 

 

Does anyone know the correct order for the LVDS and Arnet PCI cards?

 

 

 

 

 

 

 

 

 

 

[Dave S]

It doesn't matter. The LVDS and ARCNET PCI cards can go in any PCI slot.

[Minilab service]

I have QSS3111 manuals, but LVDS and Arnet PCI cards are not there. They are on PC service manuals.

 PCI-ARCNET conversion PCB is J390342 and PCI-LVDS conversion PCB is J390343 . LVDS and Arnet PCI cards can be inserted into any PCI slot. Then need to install drivers.

Edited February 27 by Minilab service

[arturo huevo duro]

4 hours ago, Dave S said:

No importa. Las tarjetas PCI LVDS y ARCNET pueden ir en cualquier ranura PCI.

Or how can I check where I'm having problems with the fiber optic cable?

 

 

 

 

 

[arturo huevo duro]

4 hours ago, Minilab service said:

Tengo QSS3111 manuales, pero las tarjetas LVDS y Arnet PCI no están ahí. Están en los manuales de servicio del PC.

La PCB de conversión PCI-ARCNET es J390342 y la PCB de conversión PCI-LVDS es J390343. Las tarjetas LVDS y Arnet PCI pueden insertarse en cualquier ranura PCI. Luego hay que instalar los controladores.

Or how should the fiber optic cables from the card that goes in the PCI port be connected, and in what order, since I have no communication?

 

 

 

 

 

[Dave S]

It doesn't matter which order the fibre optic cables go in the ports on the PCI card.
Just the cables with the white band must go into the white port.

Check in Windows device manager that the drivers have been loaded for the ARCNET card.
There should be 2 NKC devices shown.

There is no specific test software for the ARCNET communication on the 30 series, you have to go by the error messages.

[arturo huevo duro]

On 28/2/2026 at 4:32, Dave S said:

No importa en qué orden vayan los cables de fibra óptica en los puertos de la tarjeta PCI.
Solo los cables con la banda blanca deben ir al puerto blanco.

Comprueba en el administrador de dispositivos de Windows que los controladores de la tarjeta ARCNET se hayan cargado.
Debería aparecer 2 dispositivos NKC.

No hay un software de prueba específico para la comunicación ARCNET en la serie 30, tienes que guiarte por los mensajes de error.

What is UDA used for?

[Dave S]

The UDA is an optional external archive storage unit.

[davidlam]

For our information, J390342 had been replaced by new part no. J391317