Noritsu 135/240 AFC-II scanner mask rollers

[Balázsovics]

Hey, i'm looking for a reliable source where i can get higher quality rollers for Noritsu scanner masks, right now i have the mask mentioned in the title under surgery and so far i have not been able to find good rollers
I would also like some recommendations on the glue i should use to reattach the new rollers

(the test scanner is an S-3 on a QSS 3301)

[Minilab service]

Bottom rollers when they are mounted on rods should have correct external size. Metal rod has 5.9 mm size ( area where monted rollers ) . The same size has 6 mm wood drill bit ( plain area ) . Can use this drill bit to put there rollers and measure what is external size. The most rollers sold oline are too big ( up to 0.5 mm ) . Sometimes 240 and 135 rollers have different size ( 240 correct, but 135 are 0.3 mm bigger ) . Then scanned frames have incorrect positions. Only few sellers have rolers which have correct size. The best is to ask seller put roller on Noritsu rod ( or 6 mm wood drill bit plane area ) and measure external size ( 135 and 240 lanes ) .

Top roller's size is not so important. They do not make film advance and just press film to bottom rollers. They shouldn't be too small and material shouldn't be slippery.

[Balázsovics]

Alright that's good but i still don't know what glue i should use

[Minilab service]

Can use any glue. Just need to work carefully. Glue can't disturb rod to rotate. Glue should hold rollers in proper positions ( rollers shouldn't move ) .

[Sunny35mm]

Hello,

Were you able to find good rollers? 

MinilabService do you know the proper external measurement with rollers on shaft it should be?

Thanks