Paper loading problem frontier S dx100

[Славен Вујасин]

Dear all

Does anyone face with this problem on Fuji DX 100?

After I got D1F2 error which is connected i most cases with APG and firmware I replace APG unit and write new firmware.

Afrer initial charge printer normaly load paper and I print few images and after printer start to going to standby mode paper was go out of roll unit insted to to stop on his start position(you can check video in attach).

I try everything,even change whole role unit but nothin,still same problem.

 

When paper comes out of roll unit spindle unit turs around whole time ,there is no any error no beeps. Only orange lamp is on and in maint tool status is like paper initializing. Once I also got status ready or eco mode even orange lamp is on

Forgot to say,Later I try also APG check and it was okay with no problem.

 

Only did not to try to change main board..don't know does it have a sense?

 

Thanks in advance