ez controller

[Gustavo G]

Good afternoon

I have EZ Controllers 5.71 and 6.5x. I had an older version without a dongle. I updated it, and now it's asking for the dongle. I bought the dongle, but now it's giving me an error. I don't know what to do. Is there a solution or a version without the dongle? The key is giving me this error. Is there any solution? I don't know what else to do!

[Minilab service]

Do you have this error during Ez controller instillation? If yes - install software when dongle is not connected. Connect dongle when software already installed. Then software should work and you have no error.

Ez controller 6.50 is for W8 and older Windows. On W10 should be version 6.60, or later. On W11 should be version 8.00, or later. The latest - version 8.31 .

Original Ez controller can be used with any Ez controller version. Fake dongle works only with exact version.

Any EZ controller can work without dongle. Just have to know how to do it.

 

 

[Gustavo G]

I previously had a version of EZController without a dongle, and now it's giving me an error. So I uninstalled the old version and installed EZController with an original key, but I'm getting the error shown in the image. It's a Windows XP system. If you could help me figure out how to operate it without a dongle, that would be a great help.

[Minilab service]

Ez controller 5.01 and older have only one protection. It is easy bypass it.
Ez controller 5.50 - 7.21 have two protections.
Ez controller 7.40 and later have three protections.

It is possible to bypass all of them. Just need to have proper virtual dongle. I have few of them. One version is for 32 bit Windows ( XP also ) .
Version 5.71 is for W7 and older Windows. Version 6.50 is for W8 and older. Both versions should work on Windows XP . 

Error 10048 usually see when dongle connected during Ez controller instillation. If do not connect dongle ( even if see mesage "connect dongle" ) then have no this error. Need install Ez controller. Do not connect dongle. When instillation finished need connect dongle and install dongle driver. After that need restart comuter. After restart EZ controller should see dongle and software should work without errors.

[Gustavo G]

Good afternoon, I've tried installing it several times and I keep getting the same error. I've always installed it as you instructed, but this time nothing works. Could you help me with the other version without the doggle? You can message me directly. Thank you very much. Regards.