I have this error 6082-0203 after doing daily setup on QSS-3300 Digital

[Tsubi]

My QSS-3300 Digital Printer, it's producing brownish muddy photos. Please help me what the cause and what can i do to to solve this problem. That's the pictures it produced.

[Dave S]

Probably a weak Red AOM driver. Try swapping it with the green AOM driver and see if the print changes colour. If it goes green, it will likely be the AOM driver that is the problem.

[Tsubi]

Is this normal measurements?

[Dave S]

3 hours ago, Tsubi said:

Is this normal measurements?

The measurements seem to reflect the print it is reading. The Cyan value is very low, and the yellow value is very high. Like I said swap the AOM's and see if there is a big change in the test print/ readings. If all the AOM's are good there will be very little change to the test print.

[TECNOR]

If after tested AOM channel Red continue the problem then its possible your problem is laser head Red.

[Tsubi]

Thank you. I will try that.

[Tsubi]

Thank you, I'm happy.

This is the good results.

[Dave S]

31 minutes ago, Tsubi said:

Thank you, I'm happy.

This is the good results.

 

Great, what did you do to get these results?

[Balázsovics]

It might just have been a poor connection, and swapping the two cleared the error

 

[Tsubi]

Dave S, by just to follow your instructions, swapping of AOM, then it leads me what's the error came from. I exchange the red AOM then done daily setup continuously until I gt the results.

This my WhatsApp Number. 076 359 4185 

Let's keep on sharing and discussing. I'm so happy. 

[Dave S]

2 hours ago, Tsubi said:

Dave S, by just to follow your instructions, swapping of AOM, then it leads me what's the error came from. I exchange the red AOM then done daily setup continuously until I got the results.

Great, it's good to finish a post with a resolution and what the cause of the actual problem was.