NORITSU 3203 SD PRO

[arturo huevo duro]

I have a question about whether these are the correct processing steps for this Minilab 3203 SD Pro, or what the actual process should be. Currently, the temperatures are: P1 38.0, P2 38.0, P3 35.0.

 https://drive.google.com/drive/folders/1Pb5McW_G1yTHOFfMgHCD61ENO6dEZeV6?usp=drive_link

 

 

https://drive.google.com/drive/folders/1Pb5McW_G1yTHOFfMgHCD61ENO6dEZeV6?usp=drive_link

 

https://drive.google.com/drive/folders/1Pb5McW_G1yTHOFfMgHCD61ENO6dEZeV6?usp=drive_linkhttps://drive.google.com/drive/folders/1Pb5McW_G1yTHOFfMgHCD61ENO6dEZeV6?usp=drive_link

 

Edited September 12 by arturo huevo duro

[alexvigor]

This depends on the chemicals' type, you're using.

[arturo huevo duro]

18 hours ago, alexvigor said:

Esto depende del tipo de productos químicos que utilices.

fijifulm

[alexvigor]

Which fujifilm exactly? Fujifilm produces different types of ra4 chemicals.

[PHOTOLABPART.COM]

Respected Sir 

 

6076-0002 Polygon Mirror Frequency is out of range 

6073-Carry out R Laser Output ON, G Laser Output ON and G Laser Output ON of Output Check→Printer→Engine Section. If the results are shown below, each laser is normal.

[arturo huevo duro]

On 13/9/2026 at 12:31, PHOTOLABPART.COM said:

Respetado señor

 

6076-0002 La frecuencia del espejo de polígonos está fuera de rango

6073-Realizar R Salida láser ON, G Salida láser ON y G Salida láser ON de la sección de comprobación de salida→Impresora→Motor. Si los resultados se muestran a continuación, cada láser es normal.

That error started appearing.