Sean M Posted October 9 Report Posted October 9 Our V100 will occasionally not cut. It seems like the leader card will "skip" as it's taken up as the canisters are about to be cut. Anyone had this issue? It doesn't seem to be the leader card as it doesn't matter whether we use a used or newer card. Perhaps the racks are worn down?
davidlam Posted October 12 Report Posted October 12 Is "occasional not cut" happened on the LEFT or RIGHT film lane or BOTH of them?
Sean M Posted October 14 Author Report Posted October 14 It happens on both of them. The sensors seem fine because what I have to do when this occurs is shift-unlock, and with your fingers physically press with the actuators all the way until the blades cut. What's happening is that there's not enough pressure to actuate because the leader is "skipping"(I'm not sure if there's a better way to describe what i'm getting at)
oliphaz Posted October 14 Report Posted October 14 Are the leader cards really worn? Do you hear clicking from inside the processor when it is skipping?
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now