Gpmin Posted October 26 Report Posted October 26 Hi everyone, I have a Fujifilm Frontier LP7500 showing several error messages. I will upload photos of all the errors. Has anyone experienced similar problems or knows how to fix them? Any advice or suggestions would be greatly appreciated. Thank you!
TECNOR Posted October 26 Report Posted October 26 Hi, first check power supply of processor control, after try upgrade processor control pcb. Gpmin 1
Minilab service Posted October 27 Report Posted October 27 Faulty processor power supply PS2 . There should be 24V output and it is missing. Gpmin 1
Gpmin Posted October 27 Author Report Posted October 27 Hello,we have changed it(we had another one from 3201 sd) now the densitometer is printed from above as a photo and the belt is not rotating
Gpmin Posted October 27 Author Report Posted October 27 6 hours ago, Minilab service said: Faulty processor power supply PS2 . There should be 24V output and it is missing. Hello,we have changed it(we had another one from 3201 sd) now the densitometer is printed from above as a photo and the belt is not rotating
Gpmin Posted October 27 Author Report Posted October 27 20 hours ago, TECNOR said: Hi, first check power supply of processor control, after try upgrade processor control pcb. Hello,we have changed it(we had another one from 3201 sd) now the densitometer is printed from above as a photo and the belt is not rotating
TECNOR Posted October 27 Report Posted October 27 Check any bad contact in the socket densitometer Gpmin 1
Minilab service Posted October 27 Report Posted October 27 Check connectors in processor section. Might be when you removed power supply accidentelly disconnecected some connectors which are on boards. Fuji LP7500 is Noritsu QSS3702F . On Noritsu is colorimeter - not a densitometer. Here is not a problem with colorimeter unit. Your Noritsu dryer has two solenoids : SOL16 ( dryer selection solenoid 1 ) and SOL17 ( dryer selection solenoid 2 ) . Remove dryer cover, on cover sensor put magnet, go to output check menu and test these solenoids there. These solenoids make output lane selection. When solenoids do not select correct lane then test print instead to go to colorimeter goes to the top. You can take this test print and insert it into colorimeter unit manually. Gpmin 1
Gpmin Posted October 29 Author Report Posted October 29 On 10/27/2026 at 6:56 PM, Minilab service said: Check connectors in processor section. Might be when you removed power supply accidentelly disconnecected some connectors which are on boards. Fuji LP7500 is Noritsu QSS3702F . On Noritsu is colorimeter - not a densitometer. Here is not a problem with colorimeter unit. Your Noritsu dryer has two solenoids : SOL16 ( dryer selection solenoid 1 ) and SOL17 ( dryer selection solenoid 2 ) . Remove dryer cover, on cover sensor put magnet, go to output check menu and test these solenoids there. These solenoids make output lane selection. When solenoids do not select correct lane then test print instead to go to colorimeter goes to the top. You can take this test print and insert it into colorimeter unit manually. Thank you!problem solved!
Gpmin Posted October 29 Author Report Posted October 29 (edited) On 10/27/2026 at 3:32 PM, TECNOR said: Check any bad contact in the socket densitometer Thank you! Edited October 29 by Gpmin
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now