Jump to content


  • Posts

  • Joined

  • Last visited

  • Days Won


Everything posted by purnomosetiawan

  1. worth to try, ditch fujifilm software, use Noritsu Software. Fujifilm software never been updated for years, we get better prints after using Noritsu Software, all new paper profiles are there.
  2. first of all, NEVER do Power clean more than 2x in a row, it will destroy your head. If after first power clean you got nothing, keep the printer idle for few minutes, longer is better. After 2nd power clean and you still got nothing, take out the ink dumper and makes sure you have inks inside, if you have not ink, pull it using syringe. Mostly the printhead is fine, the problem is weak pump. the head get destroyed because excessive power clean.
  3. question, if i have 3701 and 38 series, can both machines controlled by one computer ? so i do not need 2 operators
  4. what is the ddiference between 37 and 39 series, except for RHoS
  5. just reset it with service softwarethen you aregood to go...but honestly i never seen this printer reaching this point,most of my customer dump this printer way less than that. they already BEP their investment, so instead of repair broken printer, they got a new one with new warranty. But let say you want to keep using the printer at that point, you should replace all piping unit, dumper etc before reset it, but mostly only reset the printer is fine.
  6. the problem is not the printhead, it's always the pump that gone bad first,because the pump is bad, it caused a lot of air into the dumper. replace the the pump and make sure the dumper is free from air than you're good to go. i had this expensive lesson before. for start you can check the dumper first, make sure there's only inks not air inside.
  7. check the ink dumper, make sure the ink is full in the dumper.
  8. nope it's not related to paper movement, it's data corrupted. posibility is printer cable, flexible head cable or the worst thing is mainboard failed
  9. once i my friend after replacing AOM from China, a month later the laser gun failed, is it coincidence or AOM from china caused that fail ? i dont know, but i prefer used original AOM, or refurbished original AOM than new one but from China
  10. Noritsu, it's no brainer....Fujifilm is dead
  11. before doing anything, check your chemical first, do a proper control strip first
  12. measure the black lines from paper leading edge, make sure it's always at the same spot,if it happened only for long print check paper advance unit , see if there is something broke or irregular movement
  13. is that mean the new type can be fixed ?
  14. E-9901 is fatal error A printer system error occurred. Delete all print jobs remaining in the operating system's print queue. Turn the printer off. Check if there is any paper remaining inside the printer, and then turn the printer back on. Contact service support if the error continues to occur.
  15. 1102 is error for tube maintenance, just reset tube value
  16. anyone knoews the new part number for fuji dx100/d700, i'm looking the revised Right Ink House, i only have the old part which was has serious defect, and i know epson revised this part but i dont have the number. thank you
  17. scan computer pakai antivirus yang bagus
  18. coba tetap di scan, apakah gambarnya tersimpan dengan baik, kalau gambarnya tetap tersimpan dengan baik kemungkinan besar masalah di software (PC), coba direstore dulu softwarenya paling buruk diinstall ulang saja .
  • Create New...