Jump to content

PRASANNA PHOTO TEC

Members
  • Content Count

    38
  • Joined

  • Last visited

    Never

About PRASANNA PHOTO TEC

  • Rank
    Advanced Member
  1. ok you have to test laser frist, 1) open upper covers 2) remove screw where fix laser unit 3) pullup 70% angale laser unit ( distrbution side) 4) put some paper pcs interlock swichs 5) see machine is ready to print mode 6) take whaite paper pcs (lick set up print back side) 7) the laser unit under side have small solenoid and door 8) near door put paper pcs (no 6) 9) send scaner side some of test print lick paper set up 10) see laser unit have some expose light to paper pcs ( its very small light , please check your room light off ) 11) check 2-3 times 12) tel me what happen
  2. i confuse. the set up print are nomal? can see any colours? or all made prints are white ( blank)?
  3. its a LDD 20 problam , please check with it another machine , or replase pcb, or send us repair it
  4. DL 600 can make prints by synthetic paper? any one use this?
  5. if u dont have control srip ( original) you get 5'' paper magazine 16'' lenth paper pcs ( not fogy), and put stip holder , then process if no have stip holder you can try dark your lab and insert DEV rack. then see what happen next is high cost....frist try this before wast more money
  6. do u have contoll strip holder? if have put un fogy paper pcs, ther run controll strip menu, (preoperation) see white again is the same bad white / check your temp is 38/ all ok please change BL tank also change ps tank
  7. do u have contoll strip holder? if have put un fogy paper pcs, ther run controll strip menu, (preoperation) see white again is the same bad white / check your temp is 38/ all ok please change BL tank
  8. yes u can make it home, past small plaster arround the all rolles.
  9. did u check paper feed and check same white? prasanna
  10. see the power unit all leds lighting green? not pcb. alpha power unit
×
×
  • Create New...